So I edited the file /etc/pulse/default.pa as described by Léo Léopold Hertz $ gedit /etc/pulse/default.pa # make changes as in method a or b below The GUI paprefs tried to combine one HDMI with one analog output, instead of both hdmi. Or issue: pactl unload-module module-combine-sinkīecause LeonidMew was asking about 18.04 (I'm using 18.04.2), here's my version. To unload the module from the command line and reset PulseAudio to defaults, just restart PulseAudio with: pulseaudio -k In case paprefs does not do the job or if you prefer to have paprefs not installed, use this command from the command line: pactl load-module module-combine-sink The changes may need a restart of PulseAudio to take effect, either by logging out and back in to your session or by running pulseaudio -k in a terminal. In this example it is shown for an HDMI-device, but, as soon as your Bluetooth device is recognized, it will also be available for simultaneous output. The additionally created audio output device for simultaneous output may be selected in the Output tab from the PulseAudio Sound Preferences menu ( pavucontrol): Then in the terminal run paprefs, select Simultaneous Output tab, and check Add virtual output for simultaneous output on all local sounds cards. With paprefs you have access to a virtual output device that enables simultaneous output to all attached sound cards and devices: sudo apt install paprefs
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |